Polycom

Polycom Enabling the Web Interface

The VoIP Help Page Team·1 min read·Last updated: March 14, 2026

### Scope

This article outlines how to enable the Web Interface of a Polycom device from the phone's settings

Note: CCX 400 phones running software prior to UC Software 6.2.11 don’t support access to a system web interface.

How to Enable the Web Interface of a Polycom

1
In your Polycom device, go to Settings
2
Select Advanced
3
Enter the Admin Password(if it is not yet provisioned the default is 456)
4
Navigate to Web Server Configuration
5
Enable the Web Server
6
Configure Web Mode: (Choose the desired mode: HTTP Only, HTTPS Only, or HTTP/HTTPS. HTTPS provides more security than HTTP.)
7
Save Changes

1
After enabling the web server, open a web browser on a computer connected to the same network as the phone.
2
Enter the phone's IP address into the browser's address bar.
3
Log in with the user credentials to access the Polycom Web Configuration Utility.

Polycom Overrides

Phones & Devices

Grandstream Call Park Manual Configuration

Phones & Devices

Yealink Perform a Firmware Update

Phones & Devices

Was this article helpful?