Algo Manual Configuration

The following document will show you how to manually configure an Algo device.

Requirements:

• Access to the web gui for the device

• Access to Manager Portal

1. 1
   Log into Manager Portal.
2. 2
   Navigate to Phones

NOTE: Office Managers can navigate to Users > select the user > Phones

3. Select Add Phone and select any phone from the list to create a dummy phone, set Line Number to 1, and click add without entering any mac address. 4.  Select Phone Info for the phone you have just added.

NOTE: You will only see the information if the phone model is set to Manual or Softphon e

5. Take note of the listed information.

5. Click Cancel when you are finished.

1. 1
   Log in to the web GUI of the device. (Default password: algo)
2. 2
   Click on Basic Settings and then SIP.

3. Enter the information below and then click Save: 1. SIP Domain (Proxy Server): Domain/Proxy from phone settings. 2. Page Extension: Username from the phone settings. 3. Authentication ID: Username from the phone settings. 4. Authentication Password: Password from the phone settings. 5. Display Name: Extension name.

  ![Image](https://cdn.elev.io/file/uploads/fGEiO10cDqaLGPE064Pets2wOe6JOhqCLIPLKrgezzY/kh3ZMYz6xmSYmhT3u-PhQRgdzhPC-riy6Y7Qiq_aZLs/1646680246381-Dak.jpeg)

4. Click on Advanced Settings and Advanced SIP. 5. Click on Enabled for SIP Outbound Support.

6. Add the Outbound Proxy from the phone settings.

NOTE: The Outbound Proxy should be entered with a :0 at the end (sbc.ucaasnetwork.com:0) 7. Click on Save.