cnPilot R200/R201 Manual Configuration
This article provides instructions for manually configuring a Cambium cnPilot R200 or R201 router to work with your Hosted PBX service. It covers obtaining SIP credentials and inputting them into the device's web interface.
Scope:
The following steps will allow you to configure a cnPilot R201 manually for use with your Hosted PBX service. Tested with Firmware S4.4.2-R2
Requirements:
- Access to cnPilot web GUI
- Access to Manager Portal
Obtain SIP Credentials
- 1
Log into Manager Portal
- 2
Navigate to Phones
NOTE: Office Managers can navigate to Users > select the user > Phones
- 3
Select Phone Info for the phone you wish to register.
NOTE: You will only see the information if the phone model is set to Manual or Softphone
- 4
Take note of the listed information.
- 5
Click Cancel when you are finished
Configure cnPilot R201
- 1
Using any web browser navigate to the IP address of the router
- 2
Select FXS1/FXS2 > SIP Account
- 3
Configure the following fields, leaving all others default
- Line Enable: Enable
- Outgoing call without Registration: Disable
- Proxy Server: Enter the Domain / Proxy
- All ports should be 5060
- Outbound Server: Enter the Outbound Proxy
- Display Name: User's Name
- Account: Enter the Username
- Phone Number: Enter the Username
- Password: Enter the Password
- 4
Click Save
- 5
Reboot Device
Related Articles
Was this article helpful?