Yealink Manual Provisioning

1. 1
   From the Yealink phone select Menu.
2. 2
   Select Status.
3. 3
   Select Network.
4. 4
   Select IPv4 Status.
5. 5
   Take note of the IP address for the next steps.

1. 1
   Log in. The default credentials are admin/admin.

2. Click on Settings.

3.  At the left menu click on Auto Provision.

4. In Server URL enter the provisioning URL for your account, followed by the Global One Time Password and Username or the per device password.

5. Once the page refreshes click on Autoprovision Now. Your phone will download the config and reboot at least once. It may reboot more if it needs to update the firmware.

6. Using any web browser navigate to the IP address from the above step.

Server URL: http://ndp.ucaasnetwork.com/cfg

7. 1
   Once that is done, Click confirm at the bottom of the screen.

1. 1

   Using any web browser navigate to the IP address from the above step (They are basically the same settings from T48, with just a different look in it)

2. 2

   Log in. The default credentials are admin/admin

3. 3

   Click on Settings

4. 4

   At the left menu click on Auto Provision

5. 5

   In Server URL enter the provisioning URL for your account, followed by the Global One Time Password and Username or the per device password

Server URL: https://ndp.ucaasnetwork.com/cfg

Note: Please use http://ndp.ucaasnetwork.com/cfg as a fallback if https does not work, or if you are on a older firmware version.

6. 1

   Once that is done, Click confirm at the bottom of the screen.

7. 2

   Once the page refreshes click on Autoprovision Now. Your phone will download the config and reboot at least once. It may reboot more if it needs to update the firmware

If your phone does not provision with the DNS name try using http://129.213.10.212/cfg

Firmware versions 80 and lower only allow a limited amount of trusted certificates for provisioning, and the phone may block provisioning if this is the case. The below steps will allow disabling of trusted certificates.

1. 1

   Log into the phone's web GUI.

2. 2

   Click on the Security tab.

3. 3

   Click on Trusted Certificates on the left.

4. 4

   Toggle Only Accept Trusted Certificates to Off

5. 5

   Click Confirm.

6. 6

   Reboot the phone and it should pull the configuration.