Grandstream HT812 Provisioning

1. 1
   Follow https://voipdocs.io/articles/104
2. 2
   For Model select the appropriate Grandstream HT-8xx device.

1. 1
   Plug a phone into the #1 phone port
2. 2
   Dial \\\*
3. 3
   Dial 02
4. 4
   Take note of the IPv4 address for the next steps

1. 1
   Run an IP scanner such as Angry IP scanner to find the IP address of the device.

1. 1
   Using any web browser navigate to the IP address of the phone
2. 2
   Log in. The default credentials are admin / admin.

If these do not work, contact your current service provider or the vendor the phones were purchased from. 3. Click on Advanced Settings at the top

4. Set Firmware Upgrade and Provisioning to HTTP 5. Set the Config Server Path to ndp.ucaasnetwork.com/cfg/

6. Scroll to the bottom and click Apply 7. Click on Advanced Settings 8. Scroll to the bottom and click Reboot

This section is for "V2" versions of the ATA. To set the Provisioning URL, please navigate to the following:

1. 1

   Click on Maintenance > Upgrade > Config File

2. 2

   Then add the following:

3. 3

   Config Upgrade via: HTTPS

4. 4

   Config Server Path:  ndp.ucaasnetwork.com/cfg/

5. 5

   Config Server Username: Prov_Admin

6. 6

   Config Server Password: GOTP or the User Device's Password (Seen in the Portal)

7. 7

   Click Save and Apply

8. 8

   Reboot the device and the changes will be applied