cnPilot R200/R201: Manual Configuration

Scope:

The following steps will allow you to configure a cnPilot R201 manually for use with your Hosted PBX service. Tested with Firmware S4.4.2-R2

Requirements:

• Access to cnPilot web GUI

• Access to Manager Portal

Obtain SIP Credentials

1. Log into Manager Portal
2. Navigate to Phones NOTE: Office Managers can navigate to Users > select the user > Phones
3. Select Phone Info for the phone you wish to register. NOTE: You will only see the information if the phone model is set to Manual or Softphone
4. Take note of the listed information.
5. Click Cancel when you are finished

---

Configure cnPilot R201

1. Using any web browser navigate to the IP address of the router
2. Select FXS1/FXS2 > SIP Account
3. Configure the following fields, leaving all others default
   • Line Enable: Enable
   • Outgoing call without Registration: Disable
   • Proxy Server: Enter the Domain / Proxy
   • All ports should be 5060
   • Outbound Server: Enter the Outbound Proxy
   • Display Name: User's Name
   • Account: Enter the Username
   • Phone Number: Enter the Username
   • Password: Enter the Password
4. Click Save
5. Reboot Device